Tricone Bit Operation Steps
Pre-Operation Preparation
Bit Selection: Check properly choosing the correct tricone bit for the expected formation (soft, medium, hard, or abrasive rock). Verify the size of the bit, the thread type (API connection), and the bearing type (sealed bearing, journal bearing).
Inspection: Inspect the new bit visually prior to removal from the packaging.
Check to see that all teeth or compacts are intact and undamaged.
Ensure that the bearings spin freely, with no excessive grit or, or resistance. For new bits, the cones should have no axial or radial play.
Look closely at the threads for any damage. Apply thread compound to the pin connection.
Confirm the nozzle sizes are as specified, that they are installed, and that they are clear of any debris.
Rig Inspection (Check out the drilling rig equipment, from the drill string, stabilizers, etc., and mud pumps, to ensure everything is in good working order, and will not cause unwanted vibration, or stresses on the bit.)
Hole Preparation: Ensure the wellbore is clean from debris before running the new bit in the hole. A junk basket or magnet can be used to gather metal debris of a previous run.
Running the Bit In the Hole
Handling: Take extra care when lifting and stabbing the bit into the drill string connection. Do not allow the bit to swing freely or to hit the rig floor or the casing.
Make-Up: Torque the bit to the drill string using the correct torque values. Use a torque wrench and/or make-up chart applicable to the bit size and connection type.
14
Aug
16
Aug
11
Aug
"As someone who uses a drill 8+ hours a day, durability is a must. The tiger drill has been my daily workhorse in my job for 6 months, and it has stood up better than all the high-end brands I have used. I drill through hardwood, plywood and even MDF (which clogs cheaper drills very quickly) and this drill keeps a tight chuck—no slipping bits mid-job. Also, the battery lasts a full work day (I charge it overnight once!), which saves me from undoing my work mid-job to swap batteries. Last week, I had to drill 50 pilot holes for a deck—this drill was not overheating and my arm did not hurt afterwards. For pros relying on repeatability, the tiger drill is worth every penny."
"I'm updating my bathroom and the tiger drill has been a lifesaver. I have used it for everything from drilling into tile to hang a shower caddy, driving screws into cement board to hold the backsplash, and even for assembling the vanity. What surprised me the most? I could use it easily - I'm not a 'tool person' and I could use it. The LED light is a little detail, but it makes a big difference (no more fumbling around in dark corners!), and that I don't strip screws now, thanks to the torque control. I used to dread tasks that involved drilling because I was always worried that I wouldn't get it right - but now, I even actually look forward to them. If you are planing a home reno - buy this drill. "
EN
